General Tools DCS950 Use and Care Manual download pdf (Page 20)

MAINTENANCE TIPS

• The camera at the tip of the probe is a

sensitive, sophisticated device. Do not

use the probe as a hammer or to clear

debris.

• Do not insert or bend the probe by

force. Over-bending any section of the

probe to a radius of less than 2 in.

(50mm) many permanently damage

delicate internal cables.

• Remember to power off The

PalmScope after each inspection

session.

• Do not get water on the LCD.

• Do not bring the camera into contact

with acid, fire or hot objects by using

the probe in a corrosive or extremely

hot environment.

• Avoid getting oil or gas on the camera

head by shutting off vehicles during

inspections.

• If condensation forms inside the

camera lens, let it evaporate before

using the system again.

• Remove the batteries if planning to

store the unit for months or longer.

20

1 2 ... 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments